Skip to main content
Hot Water Service

What are the common maintenance requirements for hot water systems

By January 18, 2024February 28th, 2024No Comments

If you have hot water systems in your house, you don’t have to wait till it develops a fault before you start carrying out maintenance checks. Your hot water system provides you the comfort you need, so you must keep them in the best condition.

By carrying out a few small, simple maintenance checks, you. It prolongs the lifespan of your water heater, increases its efficiency, and enhances its performance.

What are the common maintenance requirements for hot water systems 1

But what are the maintenance requirements for a hot water system? This article will explain everything you need to know about maintaining your water heater.

Hot water system maintenance requirements

  1. Carry Out Inspections Every Two Months or More

Carrying out a routine inspection will help you determine the state of your water heater. During inspections, there are specific things to look out for, they include:

  • Leaking pipes or leaks from the bottom of your water heater.
  • Aged gaskets or loose connections. Also, check for loose screws that need tightening or replacing.
  • Corrosion on the pipes or other parts of the water heater.
  1. Flush the Water Heater Once to Twice a Year

Flushing the tank every once or two years will help to eliminate sediment build-up. This is one of the best maintenance services you can perform on your water as it not only gets rid of dirt in the tank but also helps to increase its longevity, efficiency, and performance.

  1. Check the Anode Rod

The anode rod is a very essential part of your water heater. It’s located inside the water and helps prevent corrosion. The anode rods need to be checked and replaced every three to five years, depending on the rate of corrosion discovered.

  1. Test the Temperature and Pressure (T&P) Valve Every Year

A bad T&P can cause over-pressurization inside the tank, which leads to low performance or even cause the tank to explode. During maintenance, check the T&P and replace it if necessary.

  1. Check the Thermostat Setting

Water heaters should be set between 120°F and 140°F. The level of the temperature determines how much energy you’re able to save and the efficiency of your water heater. When selecting the thermostat level, ensure it’s not below 120°F as this may cause bacterial growth, and any above 140°F can cause scalding.

  1. Insulate the Water Heater and Hot/Cold Water Pipes

You can use water heater blankets to insulate your water heater tank. These blankets can be obtained from any hardware store. You use these blankets to protect the tank and connecting pipes as it will help to save on energy and money in the long term.

  1. Lower the Temperature Settings When You Leave

Some water heaters are designed to lower the set temperature whenever you’re absent so you can save more on energy. You can achieve this effect by adjusting the thermostat to a lower temperature. Ensure to switch the water heater back on when on your return; otherwise, you may have to deal with taking a cold shower.

What are the common maintenance requirements for hot water systems 2


Suppose you lack the necessary knowledge to inspect or maintain your water, contact a professional. A professional plumber has the knowledge and skill to maintain your water heater and carry out repairs if need be.

At Modern Plumbing Group, we provide hot water service, including inspection, maintenance, and repair services. It’s essential to inspect your water heater regularly to prevent dangerous problems in the long run.

Contact us to learn more about our hot water service and get started!

Leave a Reply